The recently released MacBook Pro with PROLED XDR Display features a return of the iconic glowing Apple logo, a design element absent from the company's laptops since 2016. Because the new tandem OLED panel does not utilize a traditional backlight, Apple engineered a distinct solution to illuminate the rear logo. A teardown conducted by iFixit reveals that the effect is achieved using a strip of four LEDs positioned behind the display assembly, which directs light through a diffuser to create an even glow.
To maintain a metallic, reflective appearance when the laptop is powered off, the Apple logo itself is finished with a two-way mirror coating. While this design successfully mimics the aesthetic of older MacBook models, the implementation creates significant challenges for repair. The logo components are situated directly behind the tandem OLED panel, meaning that any failure of the lighting system likely necessitates a full screen assembly replacement.
During the disassembly process, iFixit reported that attempting to remove the display panel resulted in the glass layer delaminating and cracking the OLED and capacitive layers. This confirms that the display is not intended to be serviced at the component level. Despite these difficulties, the laptop earned a repairability score of five out of ten, marking a slight improvement over previous iterations, though many core components such as memory, NAND storage, and the HDMI port remain soldered to the logic board.
Beyond the display, the teardown highlighted several structural adjustments made to reduce the device's overall weight. Apple utilized less aluminum in the chassis and lid, and incorporated a slightly smaller trackpad compared to the M6 MacBook Pro. The hinge mechanism was also reinforced to accommodate touch-based input, which iFixit noted provides increased stability and reduced wobble when the screen is tapped. While the logic board requires removal to access parts like the USB-C ports, the device does not exhibit the same restrictive component pairing issues seen in some other Apple products, as the touchscreen and Touch ID sensor remain functional after a board swap.
